LabVIEW and Netburners

[tpannone]

I know that there are third-party add-ons to allow LabVIEW to run on platforms like Raspberry Pi and Arduino.

Has anyone attempted to create an add-on to allow LabVIEW to run on Netburner core modules?

[tpannone]

I will take the lack of replies as a no.

[pbreed]

You can use the TCP capabilities of LabView and write a driver?

[tpannone]

That would be way above my paygrade.

[TomNB]

I have not tried this myself, but the labview people think it is doable a few steps: https://www.ni.com/getting-started/set- ... et-connect