NetBurner Community Forum

Hi,
I am trying to connect Mod-Dev-70 Development Board to my laptop but every-time its showing driver not installed error. I am using Windows 7 64 bit. I was able to successfully connect the board to my desktop with same operating system. Did anyone else face similar problems regarding this development board. Thanks in advance

Regards,
TM

Did you try going to the folder C:\nburn\NetBurnerUSB_DriverInstall and install the driver ?

Seulater is on the money. The installer one or two releases ago (perhaps while still in Beta??, can't remember) did not automatically run the USB driver installer. The fix was to run it as seulater describes. I think this is corrected in the latest non-beta release.

Hi,
Thanks will try and let know the result.

Regards,
TM

Thanks that worked, It was getting frustrating. Thanks again.

Regards,
TM