NetBurner Community Forum

Tom. Not able to get to a prompt. It's stuck in a loop and I cannot break it.

This is what I'm seeing.

========================================================

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700 FS =00
Faulted PC = FF800348
D0:00000000 00465000 0000AAAA 00000001 00000000 5DFC8FAE CF206080 15001080
A0:4003AAAA FF810094 20000584 FF80016C FF80016C FF80036E 200007FC 20000634

Trap occured
Vector=05FMT =00 SR =2700
=============================================================================

Any ideas?

That would explain the behavior of the link. The device is constantly resetting. If you cycle the power, do you see any messages before the trap messages occur?

No I don't. it immediately starts displaying the traps.

In that case I think you will need to contact sales and submit it as an RMA. I can't think of anything that would cause that to happen.