MOD5234 JT1 (26-pin) Pinout

[tk1390]

Hi,

I want to characterize some functionality of the GPIO and to make this a little easier I wanted to temporarily short two pins together without soldering them. I noticed the 26 empty locations of the JT1 header on the MOD5234 and wanted to add some headers jumper different pints together. It doesn't look like its meant as an empty breadboarding location as there are some traces leading to some of the pins. Does anyone know where I can get pin out for this connector?

Thanks!

[TomNB]

Hello,

That is a factory test connector. There are no signals there for general use.