NetBurner Community Forum

Hi, I had the same problem and found that you can make it work if you clear the interrupt flag after checking the state. Here what I did for IRQ7 on a Nano board: uint8_t bMuteState = 0; INTERRUPT( IO_IRQ_7_ISR, 0x2300 ) { Pins[ 9 ].function( PIN_9_GPIO ); bMuteState = Pins[ 9 ]; Pins[ 9 ].function(...

That's great! I guess we'll have to update the serial port driver in our software to add some time between each character we send
since we might encounter more v1.02 boards for a while...anyway, thanks for the fix!

Hi, yes it works fine at 57600.

Thanks for checking this out. We see this issue using our own controller board and the Nano carrier board (rev1.3). We've also tried using MTTTY and putty and the problem follows the Nano board with the v1.02 boot monitor. Other than the serial issue, the Nano board is working fine which is why we s...

We're using a script to configure the IP addres etc. of our nano boards using the serial monitor interface which runs at the default 115.2kbps. After sending a shift-A at power on we send the 'setup' command at the 'nb>' prompt. When sending 'setup' to a board with the new 1.02 monitor, it'll print ...