NetBurner Community Forum

Guys

I found out what the cause was...It is not MOD5270. (also not arp update, not subnet/mask,...)
I almost went wrong direction. I had 100% of packets being around 1 ms response when I have my laptop ping a linux pc (with direct connection)... So I almost pointed my finger to MOD5270 because ...

Connection is direct connection.

laptop (10.1.1.6) ------ MOD5270(10.1.1.1)

ping 10.1.1.1 -t (from 10.1.1.6)

I used wireshark to see what is going on and I did see periodic arp request from laptop. But it doesn't seem arp table update delays any traffic flow. It shouldn't affect echo reply ...

2.7.5

I just wanted to see the response time of the board as i can not measure serial to serial. Arp request is sent for the first time to resolve mac and IP address. But once it is resolved, there is no need to send arp request... If you ping any directly connected normal network device, you don't see ...

Hi I am new to netburner. I am working on a project that I need very fast serial to serial connection. I need to send about 8 byte of message stream coming to one serial RX every 15 msec to another serial TX less than 1 msec. and occasionally I need to add some other longer messages.

Before ...