NetBurner Community Forum

I tried using the manual initialization, but it still only works for the 8 channels as it did before. The only thing that I can think of is it may have been when i first was learning i made a GPIO program and may have used those pins and set them to GPIO, but I don't think that should have effected ...

I seem to have encountered another problem with this. I was able to get the PWM working on a few of the eTPU pins but not on all 16. About half of them remain on and at full power no matter what I do. Is there a way to reset the pin to a default off to try to redo it, or any other ideas?

Yes.

I was wondering if there was a way to read input voltage to a certain pin, in such a way that I can use my 5234 as a sort of DAC. Please let me know if y'all know of anything. Thanks.

I am using the 5234. Do you now of any tutorials on Pulse Width Modulation using the MOD 5234?

For now it will be dimming a LED for a calibration system. It will be an output.

I was trying to control the voltage that is output using an general I/O pin. Are there any commands that can help me do this?

Never mind. I found documentation on what I needed. Thanks for all the help.

I got the input into MTTTY working. Sorry fr giving you a hard time about it. I corrected my jumper settings and all. But now after I type in FLA to load a program it takes it a long time and when it has not made any progress, I cancel it and it gives me an error of "Errors were occurred in dow...

I have Rev 1.7 . And the UART0 is connected through the serial port on the dev board. It comes up with the information in MTTTY when I reset the dev. board that says "Waiting 2 sec... 'A' to abort" but it won't let me input 'A'.