NetBurner Community Forum

Thank You for your answers, Tod, I "solved" the problem... I hope you won't kill me:). I found an IP addresses collision on our intranet, so I wasn't connecting to netburner but to the regular PC:). As we need it, I use static IP addresses and I picked one address from range reserved for this ...

Thanks for reply, Tod. I had the same idea, that the username and password will disappear by uploading new software, but it seems it doesn't work. I tried that workaround by writing authentification function but with no effect. I tried to test it on different module and it worked fine. AutoUpdate ...

Hi,
thank You for the answer. I tried to do it as You wrote, but it didnt help. I have no problem to download software to other modules I have (let's say I have 10 of them). It seems it is connected with that one specific module itself. IMHO this module had already been by customer and it came back ...

Hello,
I have received new NetBurner module MOD5234. Usually I have no problem to upload new software into it. However, in this case AutoUpdate asks me for User Name and password which I never had put before. I have to upoload software via RS232 now. Is there any solution to reset password and ...

Hello,
as I think about that - is there any need to place some filter resistors and capacitors into the circuit, or is it prepared on the MOD5234. I mean e.g. 24R4 resistors in RX paths or 49R9 from TX to 2.5V and 10nF + 24R9 from RX to the 2.5V voltage... Or the only thing to do is to place the ...

Thank You very much!

Jan Mrazek

Hello,
does anybody know, how to connect the J3 connector (10pin) to the ethernet jack? Im not sure with those LED outputs. Can I power them (20mA each one LED) directly by the 2.5V voltage output form the MOD5234 (pin 3 and 6)?
:?: How should I connect the LEDs?
1) pin 3 -> resistor -> LED anode ...

I frgot...

The humidity in the climate chamber was set to 0%.

Jan Mrazek

Hello,
thank you for your answer.

I didn't measure the 3.3V rail, and I hadn't use any certified cable. But - everything was fine for ca 5 minutes (quite a long time) util I tried to download the firmware. The download Itself made from Eclipse was successful !! (if the ethernet cabel had been ...

Hello,
I want to ask, if there anybody had some problem to programm MOD5234-100IR via ethernet while its temperature was about -40°C (ca -40°F). Today I tried to do a device temperature test, it was OK, but when I wrote new program into MOD5234, it totally collapsed - no boot text in console, no ...